Marine Water-Injected Wet Exhaust Elbow / Mixing Riser With Raw Water Inlet - Used

Marine water-injected wet exhaust elbow / mixing riser with side raw-water inlet spud, molded rubber jumper hose, and a drilled water-injection ring at the discharge lip. Flanged exhaust inlet turning approximately 90 degrees into a straight discharge barrel.

Application: Not verified. No engine make, model, or serial was supplied with this part and no legible manufacturer or part numbers are present, so no fitment is claimed. Sold by photographs, identifiers, and dimensions. Approximate flange bore 4–5 in and flange OD 6–7 in (estimated from photos, not measured) — request measurements before ordering.

Condition: Used, untested take-off (Grade C). Complete as pictured with hose and clamps. Heavy heat scale and paint loss on the discharge barrel, surface rust on the flange face, and corrosion staining around the water-jacket area. No pressure test, flow test, or bore-scope has been performed — a hydrostatic/air pressure test of the water jacket is strongly recommended before service use. Material (copper alloy vs ferrous) not verified.

Item will be drained, flushed, and ports capped before shipping.

Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase.

Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.

Quote is subject to final fitment confirmation by engine/transmission serial number, part number, photos, and supplier availability.