Bronze Marine Raw Water Pump Body / Cover Housing with Hose Outlet - Used

Cast bronze marine water-circuit housing — most consistent with a raw-water (sea-water) pump body or pump end cover with an integral offset hose outlet and a small secondary side port. Circular mounting flange with four bolt holes, machined rear bore with a stepped counterbore for an impeller/seal register, and an external groove near the discharge tip.

Application: NOT VERIFIED. No manufacturer name, casting number, or part number is legible on this piece, so no engine or pump model is claimed. Approximate measured dimensions: ~4.5 in overall height, ~3.5 in flange diameter, ~1.25 in discharge bore, ~0.5 in side port.

Condition: Used, untested take-off. Dried salt/scale film, storage grime, light oxidation at the bolt bushings. No cracks visible in the photographs, but the casting has not been pressure- or crack-tested. Housing casting only — no impeller, cam, wear plate, seals, gaskets, or hardware included. Drained and ports capped before shipping.

Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase.

Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.