Starter Motor Commutator End Cap With 4-Brush Holder Assembly - Used

Starter motor commutator end cap with integral four-brush holder assembly, removed from stock. Cast end head with single insulated terminal stud, four brush boxes with brushes and coil springs installed, brass brush plate, and a four-hole mounting flange. Approximately 5 in. outside diameter.

Application: Not verified. No manufacturer tag or legible part number is present on this unit, so it is offered by photographs, identifiers, and dimensions only. It is a common heavy-duty DC starter / motor end-cap configuration; the buyer should match it by starter make and model, bolt-circle and through-bolt pattern, armature bushing bore, brush size, and terminal stud size. Additional measurements can be provided on request.

Condition: Used, untested take-out. Appears complete as pictured with all four brushes and springs present. Surface rust and age patina throughout. No electrical testing, continuity check, ground-isolation test, or brush-wear measurement has been performed, and none is implied.

Quote is subject to final fitment confirmation by engine/transmission serial number, part number, photos, and supplier availability.

Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase.

Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.