Unidentified Machined Steel Bushing / Bearing Sleeve With O-Ring Groove - Used

Machined steel bushing / bearing-and-seal sleeve with a stepped bore, internal shoulder, seated O-ring, and a small drilled lube or drain port. Approximately 4 in outside diameter by 2.5–3 in long (photo estimate — exact caliper measurements available on request).

Application: NOT VERIFIED. This part carries no visible manufacturer name, logo, casting mark, or stamped part number, and no source assembly has been established. It is offered strictly by photographs, visible identifiers, and dimensions. Any handwritten numbers seen in the photos are workbench inventory markings, not part numbers.

Condition: Used, untested take-off. Surface rust on the outer diameter and one face; bore and sealing land show light scoring and discoloration; the fitted O-ring is a used seal and should be replaced.

Quote is subject to final fitment confirmation by engine/transmission serial number, part number, photos, and supplier availability.

Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase.

Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.