Fabricated Welded Steel Angle Mounting Bracket With Gusset - Used

Welded steel angle mounting bracket with triangular gusset reinforcement. Two-plate construction joined at approximately 90 degrees, with a four-hole pattern on each flange (two larger holes, two smaller holes). Bright unpainted mill-finish steel, clipped corners, approx. 10–11 in long x 3.5 in wide x 3–3.5 in deep (estimated from photographs, not measured).

Application: not verified. No manufacturer name, data plate, or part number is present on the part, and no engine, transmission, generator, or vessel application has been established. The only marking is an illegible handwritten shop/inventory note on the gusset, which is not a part number. Sold by photographs, identifiers, and dimensions only.

Condition: used, untested (Grade C). Appears complete and structurally intact with light scuffing, scratching, and minor surface oxidation. No cracks or deformation visible. Not dimensionally inspected, load tested, or NDT inspected — no structural or load rating is stated or implied.

Quote is subject to final fitment confirmation by engine/transmission serial number, part number, photos, and supplier availability. Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase. Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.