Machined Steel Sleeve / Bushing With Cross-Drilled Holes - Used, Unidentified

Machined steel sleeve / bushing with cross-drilled radial holes, approximately 4 in long and roughly 1-1/2 in to 1-3/4 in outside diameter. Application: not verified — this part carries no brand, part number, or data plate, so no engine, transmission, or pump application is claimed. It is offered exactly as photographed for buyers who can match it by measurement. Possible uses include a drive/coupling sleeve, a pivot-pin or linkage bushing, or a machine adapter sleeve; interchangeability has not been established. Condition: used, untested take-off. Bright machined surfaces with light scuffing, minor discoloration around some holes, and small nicks at two hole edges; no cracks or missing pieces visible. Not tested, not rebuilt, and no serviceability claim is made. Additional measurements and photos available on request. Buyer must confirm fitment by part number, photos, dimensions, engine model, serial number, and application before purchase. Used marine part sold as-is unless otherwise stated. No returns on electrical, used, special-order, or installed parts.